今日頭條
官方微信
官方抖音
案例頻道作者：張雪莉（河北大唐國際張家口熱電有限責任公司，河北 張家口 075000）
摘要：張家口熱電公司2號機組五臺給煤機控制系統已投運十年之久，板件逐漸老化，故障率高。此外，原給煤機控制系統程序固化在存儲器中無法查看，故障發生后無法準確判斷。針對這些問題，對給煤機的控制系統進行升級改造。本文通過對其改造過程及投運后出現的問題、解決方法進行闡述。結果表明給煤機控制系統運行穩定，完全達到了預期的升級改造效果。
關鍵詞：給煤機；PLC；控制系統；自動調節
Abstract: The control system of five coal feeders of No. 300MW unit ofZhangjiakou Thermal Power Company has been put into operationfor ten years, the plates are gradually aging, and the failure rate ishigh. In addition, the original Coal Feeder Control System programsolidified in the memory cannot be seen after the failure cannot beaccurately judged. In view of these problems, the control system of coalfeeder is upgraded. In this paper, the problems and solutions after thetransformation process and put into operation are described. The resultsshow that the coal feeder control system runs stably and achieves theexpected upgrading effect.
Key words: Coal feeder, PLC; Control system; Automatic regulation
在線預覽：
給煤機控制系統升級改造問題分析.pdf
摘自《自動化博覽》2021年8月刊
北京市公安局海淀分局備案號：11010802023656號